DESCRIPTION

        ASI 306 Electronic Grade Self-Leveling Silicone is a one-component, RTV (room temperature vulcanizing) product that uses a new cross-linking mechanism as a curing method. No acetic acid or other corrosive by-products are generated during its cure. Thus ASI 306 can be used in corrosion-sensitive electrical and/or electronic equipment with no adverse effect. Supplied ready to use, ASI 306 cures at room temperature to form a tough, high-modulus rubber. ASI 306 has excellent unprimed adhesion to a very wide range of substrates including metals (i.e. chrome), glass, most woods, ceramics and various plastics. Because ASI 306 is a 100% silicone sealant, it resists weathering, moisture vibration, ozone, ultraviolet and temperature extremes. ASI 306 remains flexible from -57°C to +204°C (-70°F to +400°F).
 
 

TYPICAL USES

        ASI 306 is primarily used in applications where a flowable, self-leveling silicone sealant is required to fill small gaps or voids. Applications include potting electrical terminals and coating electrical devices. Since no undesirable odors are released during cure, ASI 306 is ideal where applications must be done under confined conditions. Adequate ventilation should be provided with extensive use of this product.
 
 


DIRECTIONS

        ASI 306 is ready to use and requires no mixing or additives. The cure mechanism begins as soon as the sealant comes in contact with the air. Uncured sealant will flow until a cured skin is formed. At conditions of 25°C (77°F) and 50% relative humidity the sealant will skin in 30 minutes and cure within 24 hours (1/8" thickness). Higher humidity accelerates cure. In applications where partial or total confinement of sealant is prevalent, the time required for proper cure is generally lengthened by the degree of confinement.
 
 

SURFACE PREPARATION

        All surfaces should be clean and dry. It is recommended that bonding surfaces be solvent wiped with a naphtha, ketone or chlorinated solvent. Suitable solvents would include xylol, toluol and mineral spirits. Do not solvent wipe with alcohols or oil-containing solvents such as Varsol. Allow surface to dry thoroughly before applying sealant.
 
 

PRIMING

        Priming for ASI 306 is normally not required for applications to most substrates. Unprimed adhesion can be readily tested by applying a small trial flow and allowing 7 days for maximum adhesion to occur.
 
 


PAINTING

        ASI 306 should not be applied to surfaces that will be painted, as painting over sealant is not recommended. The paint film  does not stretch with the extension of the sealant and the adhesion of paint to ASI 306 is not adequate.
 
 


COLORS

        ASI 306 is available in clear, white and black. Call for price and availability. FDA STATUS ASI 306 is permitted under regulations of the Food and Drug Administration where incidental food contact might be involved. FDA Regulation number is 177.2600.
 
 

Underwriters Laboratories File E209770

General Description of Material:

    100% silicone sealant furnished in the form of cartridges.

    Material Modifications - There shall be no changes in the formulation or composition of the material unless previously cleared through Underwriters Laboratories Inc.

    Form of Shipment - The materials are produced and shipped as finished products.

Click here for Full Technical Information

Back to Top